Test Software
programs, procedures or rules and associated documentation pertaining to the operation of a computerized test set.
See Also: Test Software Development, Software Testing
-
product
CAM/TRAC Test Kits
The Camtrac (registered trademark) series test fixtures provides ‘Z’ axis motion that reduces probe side loading typically seen with Clamshell type test fixtures. This not only extend the life of the probes, but additionally, provide better probing accuracy, especially on fine pitch test centers. Camtrac fixtures are available with the most widely used interfaces in the test industry.
-
product
Kid's Finger Test Probe 19
CX-19
Shenzhen Chuangxin Instruments Co., Ltd.
Children Finger Test Probe 19 is intended to simulate access to hazardous parts by children of 36 months or less.
-
product
Rapid Test Development
TestEZ® Development Suite
Count on the Test EZ® Development Suite for complete, efficient, cost-effective test development and execution for electronic test systems.
-
product
Rail Traction Inverter Test System
The rail inverter test system uses a pulse test methodology to verify proper operation of the IGBT switching elements in a subway car motor control. The system is designed to verify proper commutation of the switching elements. A large capacitor bank allows testing at DC voltages up to 1kV and peak currents of up to 3kA into reactive loads.The system also integrates self test capabilities and safe-to-turn-on (STTO) diagnostics to ensure no gross faults are present prior to the application of high voltages. Further the system includes dielectric withstand (hi-pot) test capability to ensure electrical safety.
-
product
Test Switches
Designed and manufactured to allow quick and easy multi-circuit testing of switchboard relays, meters and instruments by any conventional system.
-
product
Scalable Test Solution for Mixed-Technology Test Applications
Spectrum RF Systems
The Spectrum RF Systems are fully integrated, configurable test platforms combining several digital, analog, RF, and switching instruments to provide automated functional test solutions for a wide range of mixed-signal and microwave test applications including radars, Electronic Warfare, missile, and satellite communications.
-
product
Insulating Boots (Gloves) Withstand Voltage Test Equipment (Auto)
HTTX-HI / 530
Wuhan Huatian Electric Power Automation Co., Ltd.
AC withstand voltage test for common electrical insulation tools.
-
product
Manual Test Press Fixture
750/752 Series
RTI's manual test presses are compact, portable, all-inclusive, and easy to use. Single lever operation and 100% vertical compression makes the manual test press an ideal solution for PCB, hybrid module, and high pin count device-level testing when complex test requirements cannot be met with a test socket and breakout board alone.
-
product
IPX5 IPX6 Water Spray Test Device
CX-IPX56B
Shenzhen Chuangxin Instruments Co., Ltd.
Drop rain rain chamber Uses: This equipment is main to test the physical and other related properties of the products in the environment of simulated rain, such as electronic and electrical products, lamps, electrical cabinets, electrical components, automobiles, motorcycles and their parts and components. After the test, through the test result to determine
-
product
TAM Assistant Software
TA Instruments’ robust application for instrument control, data acquisition, data analysis, and reporting for the Microcalorimetry TAM suite of instruments. The single, intuitive user interface combines real-time instrument monitoring, experimental design wizards, and application specific analysis capabilities, providing the user a comprehensive yet simple workflow solution.
-
product
PathWave Lab Operations For Battery Test
EP1150A
PathWave Lab Operations for Battery Test enables efficient planning and coordination of your entire battery test laboratory. It manages all resources, including test fields, test systems, and your device under test (DUT). PathWave provides an integrated, web-based lab management platform that helps you modernize your test workflows, eliminating legacy paper-based processes, and increasing data integrity and traceability.
-
product
Custom Test Fixtures
Intrinsic Quality is proud to offer a variety of Test Fixture Development Services that include fixture building, tester interface building, harness building, troubleshooting, maintenance, design, and engineering. IQ’s fixtures are built to exacting specifications and configured to deliver quality production testing. Our global customers have trusted us for over 35 years to provide custom solutions applying leading edge technology. IQ consistently delivers cost-effective solutions with our client’s recognition and gratitude.
-
product
Test bench for Diagnostics of Brake Valipers
MS300
Diagnostic equipment MS300 for repair and diagnostics of brake calipers. MS300 is manufactured fromanti-corrosion materials resistant to chemical effects of the brake fluid. The tabletop and the control panel are made of stainless steel, itensuresa long-lasting service of the equipment. A pressure indicator andhigh-pressure pumpcontrol elements are located on the control panel. There is also aconnection coupling fortested units. There is a gutter along the tabletops perimeter preventing the brake fluid from draining on the floor. For convenient use of tools, there is a section with perforation on the back side.
-
product
Test Handlers
Boston Semi Equipment test handlers are designed for optimum production performance on your test floor.
-
product
HV Switch Test Equipment
KV Hipot Power Test Equipment Co.,Ltd
High Voltage testing is usually performed to qualify the device to operate safely during rated electrical conditions, a way to check the effectiveness of its insulation. The objective sought during the high voltage testing will determine the type and amount of voltage applied and the acceptable current flow.
-
product
GSM/EDGE Analysis Using NI PXI RF Test Instruments
NI-RFmx GSM/EDGE
The NI-RFmx GSM/EDGE personality is a highly optimized API for performing physical layer measurements on GSM/EDGE cellular standard signals. NI-RFmx GSM/EDGE is completely interoperable with all NI-RFmx APIs. It provides simple access to the most advanced optimization techniques such as multi-measurement parallelism and multi-DUT measurements. The result is extremely fast and high-quality measurements with minimal software development effort.
-
product
Playout and Capture Software
VPlay 3
Multifunctional easy-to-use software for multichannel broadcasting and insertion of media data with simple graphics design abilities. Vplay supports all common types of input AV-signals and transport streams, and all widespread compression types and containers of media data.
-
product
VLF Test System
BAUR PHG 70 portable
BAUR Prüf- und Messtechnik GmbH
Portable, high performance test generator with VLF truesinus technology. The BAUR PHG 70/80 portable VLF test systems are used for cable and cable sheath testing of medium-voltage cables of up to 50 kV and electrical equipment.* 3 voltage shapes in one device: VLF truesinus, VLF square wave and DC voltage* For medium-voltage cables of up to 50 kV operating voltage* Cable testing, fault conditioning, cable sheath testing
-
product
CTEK MUS 4.3 TEST&CHARGE Battery Charger and Tester
56-959
The MUS 4.3 TEST&CHARGE combines an advanced micro-processor controlled battery charger with a battery and alternator test function to provide the ultimate in battery testing, charging and maintenance.
-
product
Test Phone - Industrial (3-way Lead)
CZ20124
The CZ20124 is the first of the industrial buttinskis focusing on ruggedness, reliability, and safety. DropSafeTM and RainSafeTM technology make these butt sets practically indestructible and the voltage and current protection technologies protect you from electrical hazards. The CZ20124 comes equipped with a multi-way lead set as standard meaning connection to Krone and RJ sockets are automatic. All the features of the base model butts are included making a truly valuable test phone.
-
product
Test Fingers & Probes
Test Fingers and Probes are used in most standards to check accessibility to moving parts or hazardous live parts. They comes in many forms, such as test fingers, test rods, test balls etc.
-
product
FRP-25T Test System Interface Probe
FRP-25T
Current Rating (Amps): 5Average DC Resistance lower than (mOhm): 35Test Center (mil): 100Test Center (mm): 2.54Full Travel (mil): 160Full Travel (mm): 4.06Recommended Travel (mil): 120Recommended Travel (mm): 3.05Overall Length (mil): 1,210Overall Length (mm): 30.73
-
product
54 Piece Automotive Test Connector Kit
146
This comprehensive test kit features a variety of terminal adapter sets which enable connection to most automotive vehicle connectors, both foreign and domestic. Terminal adapters connect via the included 48 inch stacking banana plug test leads. Connection to most DMM’s and scopes is no problem. Kit is designed to provide wide testing coverage and quicken the test process.
-
product
Optics Test Systems
Mirror Collimator And Autocollimator
Optik Elektronik Gerätetechnik GmbH
Mirror collimator and autocollimator for the entire wavelength range from UV to MIR The compact mirror collimator can be used both as an autocollimator and as a telescope.
-
product
Software
DIGITIZER
The Digitizer allows the recovery of design data of unknown assemblies by an electrical analysis with a Condor flying probe test system
-
product
Double-deck High and Low Temperature Environmental Test Chamber
Guangdong Bell Experiment Equipment Co.,Ltd
DGBell’s Double-deck High and Low Temperature chamber was designed to test battery cell combined with charge and discharge equipment, and also available to thermal test for small products and components.